Drum Tuning: Tune to the Drum [Part 10 of 31]

Welcome to Day 10 of 31 Days to Better Sounding Drums. In case you’ve missed previous posts, we’ve been discussing tuning the toms over the past couple days. After seating the heads properly, it’s time to dial in these toms with some fine tuning. Tuning the toms can be a very frustrating experience. However, the method that I have learned and continue to use is very simple. Keep in mind, there is no right or wrong here. In fact, if you asked 10 drummers how they tune their drums, you’ll probably receive 10 different answers. I learned a long time ago this simple method and it works for me.

Smallest Tom First

When tuning the toms, I have always started with my smallest tom. If you only have a rack and floor tom, this will be super easy for you. On the other hand, if your smallest tom is an 8″ and your biggest floor tom is an 18″, you have to think about the wide tonal aspect from top to bottom. For me, starting with my smallest tom helps keep everything in perspective. If you tune the floor tom too high, for example, your smallest tom will be toned way too high to compensate and will sound choked and out of balance.

Place Tom on a Rug or Carpet

When tuning, I find it works best to place my tom on a small rug or piece of carpet. First, this protects the hoop AND your hardwood floors from being scratched up. Second, the carpet will actually muffle the head not being tuned so you can focus in on the head that you’re fine tuning. If the tom is sitting on a desk or hard surface, you’ll hear the opposite head resonating and will make tuning dramatically more difficult.

Fine Tuning

I’ve met a lot of fellow drummers that actually tune to an exact note. This is an ok method, but simply has never worked for me. All drum shells have a very unique tonal quality. Different woods, room size, venue, ply thickness, etc all contribute to the sound. For me, it has always worked best to simply tune the drum ‘to itself’.

Here’s how:

Using your finger, tap on the drum head near each of the tension rods (like the picture above). Using the criss-cross pattern that we talked about before, adjust each tension rod in very small increments until each section of the head have the same pitch all the way around. The key here is to use very small increments. If you go too tight, too soon, you’ve lost the sweet spot. If this happens, loosen and start again. Now, turn the drum over and tune the opposite head in the exact way. For me, tuning both heads to the same pitch of each other allows the drum to be in ‘tune with itself‘ and demonstrates the best tone and resonance.

That’s it! The point to fine tuning your toms is to listen for that “sweet spot”. The more you practice tuning your toms, the easier it is to identify when the drum is in tune with itself. Try it out the next time you replace those heads.

Be Sociable, Share!

• 

Tagged as: 31 Days to Better Sounding Drums